Certifying balancing and spinning technology manufacturer dependently

The periodic monitoring of measuring and test equipment guarantees that measurements render reliable results during the course of your manufacturing process.

The accreditation covers the following measurement parameters and standards:

  • Geometry
  • Mass
  • Unbalance
  • Rotating speed
  • Vibration velocity

If you maintain a test equipment management system or are planning on establishing one, you can considerably update it with our services.

For your safety

Simply assuming that measurement technology works perfectly is no longer enough. Verify the abilities of your machines with our tests. This is particularly important when it comes to the balancing manufacturer step: Because this is often the final step in the process and therefore an important element for the quality of your products.

Fewer process errors

Have your working standards tested and rule out any potential errors in the balancing process. Setup, test or master rotors are the "final measures" for your balancing machines as well as the foundation for machine calibration and alignment. By testing, your also protect yourself against minor deviations that could impair the quality of your unbalance measurement.

Seamless test equipment management

Integrate balancing and spinning technology in your test equipment management, rule out any respective objections during audits and convince your customers with a high quality standard.

Lower manufacturing and follow-up costs

Minimise potential quality deviations with the periodic monitoring of your measuring and test equipment. Prevent complaints and potential high follow-up cost through well-documented test certificates.

Hotline general

+49 (0) 6151 32-2311
Monday - Saturday
07:00 am - 05:00 pm

Hotline Service (Helpdesk)

+49 (0) 6151 32-3083
Monday 01:00 am - Saturday 01:00 am (24h)
Saturday 08:00 am - 02:00 pm
The given times refer to CET (UTC+1, March - October UTC+2). The current time is:
21:35

further contacts